Strymon DIG Dual Digital Delay V2
Rack-mount digital delays of the ’80s ushered in a new era of audio effects. The innovative electronic designs generated the cleanest delays that had yet been heard, but also created their own special and intriguing sonic characteristics. Thirty-plus years later, these sounds remain as distinctive and inspiring as ever.
Delve into STRYMON DIG Dual Digital Delay V2 three digital delay voicings: the early ’80s adaptive delta modulation mode, the mid-’80s 12 bit pulse code modulation mode, and the modern high-resolution 24/96 mode.
Multiply these distinct voicings by two and get DIG — your perfect dual delay ally.
So what's new on the STRYMON Deco Tape Saturation & Doubletracker V2 compact effect pedal ? :
- Full MIDI implementation means you can control just about every switch, knob, and setting remotely by sending MIDI commands from your controller or DAW via Deco’s EXP/MIDI jack or USB-C connection.
Delay Time can be synchronized via MIDI Clock Sync, and the sync setting can be saved for each preset.
300 MIDI preset locations are available for loading and saving your favorite settings.
- A premium analog JFET input circuit ensures superb responsiveness to your playing, and you can select mono or stereo input with the flick of a rear panel switch.
All this, plus a new ARM DSP chip provides more processing power for every sonic nuance, with less energy consumption on your pedalboard.
- Tone knob sets the feedback filter response for tailoring the sound of your echoes. Fast and intuitive to use, it is actually two filters on one control (turn left for high cut and right for low cut, or set at 12 o’clock for a flat response).
- SKU Strymon DIGV2
- Accurately reproduced the sound of rack-mount digital delays of the ’80s
- For electric guitar/bass, synthesizers, keyboards, effects loops, and more
- Made in USA
- 2022
- 2x simultaneous delay algorithms (Delay 1 from 20ms to 1.6s with the Time knob or Tap Tempo switch / Delay 2 with dedicated 5x subdivisions)
- 3x digital delay voicings : the early ’80s adaptive delta modulation mode, the mid-’80s 12 bit pulse code modulation mode, and the modern high-resolution 24/96 mode
- High impedance ultra-low noise discrete Class A JFET preamp input
- 520MHz ARM Superscalar processor
- Ultra low noise, high performance 24-bit 96kHz A/D and D/A converters provide uncompromising audio quality
- 32-bit floating point processing
- 20Hz to 20kHz frequency response
- Full MIDI implementation, allowing to control just about every switch, knob, and setting remotely by sending MIDI commands from your controller or DAW via Lex’s EXP/MIDI jack or USB-C connection
- 300 presets for loading and saving favorite settings
- Press and hold the Doubletracker On footswitch to achieve a recording studio-inspired through-zero flange effect
- A single TRS input jack gives the option to use a stereo input signal. A dedicated rear panel Input switch allows to set Lex for operation with a stereo (TRS) or mono (standard TS) input source. Low impedance dual TS output jacks let you use Lex as a stereo effect
- Expression pedal input allows the connection of a TRS expression pedal, MiniSwitch, MultiSwitch Plus, or TRS MIDI connection
- USB jack for controlling via MIDI from a computer or for performing firmware updates
- Lex lets you choose electromechanical relay switched true bypass for a 100% untouched signal when the pedal is bypassed (this is the default setting), or premium quality buffered bypass to preserve signal integrity (preventing high end roll-off due to longer cable runs)
- Controls : see pictures
- Connections : see pictures
- 9V DC power supply included
- Requires maximum 9 volts DC center-negative, with a minimum of 300mA of current
- 11.4 x 10.2 x 4.4 cm
- Manual : https://www.strymon.net/support/dig-v2/
- Ref. Euroguitar : 103362
