Dsm humboldt Simplifier DLX Zero Watt Dual Channel & Reverb Stereo Guitar Amp

DSM & HUMBOLDT Simplifier DLX Zero Watt Dual Channel & Reverb Stereo Guitar Amp features two fully independant 100% true analog studio grade preamp that recreates the most useful and popular preamps in the market : three preamp types (MS Brit, American, AC Brit) with three gain modes (Clean, Crunch and Lead).
Along with is a full stereo reverb, with mix control for each channel independently. ?Three reverb modes (Short Room style, Mid Plate style, Ether style).
You can use the Simplifier DLX as a stereo 2-channel amplifier, or 2-parallel amplifiers for full stereo signal chain, or with 2 guitars at the same time, each with its own amp and fx loop.

A key part of a tube amp sound and response is the tone stack behavior. The tone stack on the Simplifier is a genuine configurable three band classic amplifier topology, keeping the same feel, response and interaction of the original amp.

Power Amp Sim stage is an accurate approximation of the interaction between the power tubes, output transformer and global feedback, which produces a particular frequency response for different tubes and speakers. PRESENCE: Controls the hi-mids response just like the feedback based presence control on tube amps. Turn it up to cut through the mix or turn it down to sweeten aggressive distortions.
RESONANCE controls the low-end and resonance peak caused by transformer-speaker interaction in tube amps. Now you can control the dampening factor and get super tight low-end clarity and authority.
POWER TUBES SECTION features a three way toggle switch that mimic the different response of classic tube types (EL34, 6L6, KT88).

Tweakable Cabinet simulator that takes the heritage and experience of ©DSM Noisemaker developing the most useful and innovative cabsims of the market. You can easily dial two independent cabinet simulators panned LEFT - RIGHT with MIC POSITION controls that responds as a real CENTER/OFF AXIS microphone position adjusting the precise amount of high-end roll off you look for. A three way toggle switch allows you to choose independent cabinet STYLE for each side. 1x12 Combo, 2x12 or big 4x12 cabinet simulations that you can combine with any of the 3 preamp voicings, adding an extra dimension to your sound development.

Spread Control allows you to create a pseudo stereo imaging, by shifting the phase of one channel on selected key frequencies. It will make your sound bigger and 3 dimensional, even if you are using a mono configuration. This spread is useful to get that "dual Cab" sound with realistic physical separation, very useful for recording on a stereo track, or playing with headphones.