Cranborne CAMDEN EC2
The Camden EC2 is more than just a 2-channel preamp: it's a powerhouse of high-precision audio technology, derived from the renowned Camden 500. Designed by Cranborne Audio, it combines exceptional sonic transparency with vintage analog warmth, all in a robust 1U rackmount format, ideal for the most demanding studio setups.
This preamp delivers reference-level audio performance with proprietary "Camden" topology, Mojo variable analog saturation (Thump and Cream), and two built-in professional headphone amps for zero-latency direct monitoring. It also integrates with C.A.S.T. technology for extensive and flexible connectivity.
The Camden EC2 is the ultimate tool for capturing the most faithful recordings or adding analog character on demand.
Low-noise, low-distortion Camden topology with exceptional linearity
2 independent channels
Gain up to 68.5 dB
Equivalent Input Noise (EIN):
<-129.5 dBu (150 ohm source, unweighted)
<-135.5 dBu (common inputs)
THD+N: < 0.00025% (1 kHz, 35 dB gain, +24 dBu output)
Intermodulation Distortion: < 0.0006%
Frequency Response:
±0.7 dB from <1 Hz to >1000 kHz (35 dB gain)
±1 dB from <5 Hz to >200 kHz (full gain)
Phase Shift:
<2.75° from 20 Hz to 20 kHz (full gain) 40 dB)
<6° at maximum gain
Mojo Analog Overdrive
Two modes: Thump and Cream
Variable overdrive control with true bypass
Thump: Boosts low frequencies (160 Hz and below)
Cream: Gentle compression effect, reduces fundamentals
Built-in headphone mixers
Two channels with independent control (CH1, CH2, AUX)
Zero-latency direct preamp monitoring
Rear-mounted auxiliary inputs for mixing with interface return
Stereo mode: Pan left/right
Studio-quality headphone amplifiers
Frequency response: <±1 dB from <1 Hz to >100 kHz
Output impedance: 0.33 ohms
THD: 0.0003%
Power:
2 × 250 mW into 600 ohms
2 × 450 mW into 220 ohms
2 × 250 mW into 100 ohms
Connectivity
Balanced XLR outputs
Balanced 1/4" jack outputs
Link jack output for DI use or parallel routing
48V LED indicators:
Orange: charging or dissipation
Red: ready for use
CAST compatibility
CAST IN and OUT ports
Direct connection with 500R8, 500ADAT, N22, and N22H modules
Audio signal transfer and headphone return via a single RJ45 cable (Cat 5e/6/7)
Power supply
External 24V / 1.25A power supply
Secure connector
Ref. Euroguitar : 116765
