Shure PSM 200 EP2TR215-Q3

ese artículo ya no está disponible a la venta

Un consejo ? ? 03 20 88 85 85
Shure PSM 200 EP2TR215-Q3

Using a Shure monitoring system allows you to hear the music via your earphones at the exact time it is played. There can be a short delay in music coming out of the wedge, which can cause performers to play out of time. Wedge monitors will sound fine when standing in one position, but if you move to the left or right, that sound is likely to change. With in ear personal monitoring, the sound will be constant and comes with you, wherever you go. Using wedge monitors long term can also be damaging to your ears. Using Shure sound isolating earphones cuts out the sound around you leaving you to focus on playing in time. Simply connect two line-level or mic–level inputs directly into the transmixer. Set the frequency on the transmixer using a single button, and the same again on the bodypack receiver. Connect your earphones to the P2R, set up your desired mix using the personal mix controls on the front of the transmixer and you are now all ready to go.

RF Output Power 10 - 30 mW (countryspecific)
Operating Distance Up to 100 m
Harmonic distortion 1.5 % typical
Signal-to-noise-ratio 80 dB (A) typical
Listening mode mono
Compatible Systems per band (up to) 4
Transmitter Inputs 2x XLR/6,3 mm combo, mic/line level
Transmitter Outputs 2x XLR split outputs
Wired Bodypack Option Yes
Personal Mix Control On transmitter
Remoteable Transmitter No
Battery Life Wired 6 h; Wireless 4 h
Frequency Response 30 Hz - 12 kHz

Further technical specifications PSM®200 System
RF Carrier Frequency Range 518­-865 MHz (country dependent)
Modulation FM +/- 35 kHz Deviation (Nominal)
Operating Temperature -7 degrees C to +49 degrees C (+20 degrees F to +120 degrees F)

EP2T TransMixer
Modulation Limiter Internal peak limiter (>10:1 hard knee compression)
Antenna 1/4 Wavelength, semi-rigid, PCB Mount
Connector Type XLR/1/4-inch combo
Nominal Input Level 25 dBu @ 1/2 volume (12 o\'clock)
Maximum Input Level 5 dBu @ 1/2 volume (12 o\'clock)
Current 170 mA maximum

Dimensions 220 x 140 x 40 mm (8.6 in. x 5.6 in. x 1.7 in.)
Net Weight 370 g (13 oz.)

P2R Receiver
RF Sensitivity 109 dBm typical
Squelch Threshold 102 dBm typical
Antenna attached Whip
Audio input connector connector type: 1/4-inch mono
Impedance 1 megohm
Maximum input level LO = +0 dBu; HI = 10 dBu
Frequency Response 30 Hz to 20 kHz (+/ 3 dB); earphone dependent
Power Requirements 9 V alkaline battery, Duracell® type MN1604 recommended
Audio Output Connector 1/8 inch (3.5 mm)
Minimum Load Impedance 8 ohms

Weight 100 g (3.52 oz.) less battery
Dimensions 122 mm x 73 mm x 32 mm (4.809 in. x 2.875 in. x 1.251 in.)

SE115 Earphones
Frequency Range 22Hz – 17.5kHz
Sensitivity 105dB SPL/mW (@ 1kHz)
Impedance 16 Ohms (@ 1kHz)
Input connector 3.5mm (1/8”)
Colour clear
Cable Length 157 cm (62”)

Weight 30g (1oz)